Technical Data.
High-speed strip-feed presses
Our high-speed presses stamp and form round and irregular lids and bottoms for three-piece cans and pails. They are also suitable for the production of pre-drawn caps for 2-piece cans and twist-off caps.
Key features of our presses are:
- Symmetric and double-column construction of the press frame. Press frame and support construction (foot) separated. Thus, body deformation remains completely symmetrical under the influence of the press forces and the heat which occurs during operation.
- Automatic oil lubrication for guiding and actuating parts allowing for an optimal control of the heat build-up and guaranteeing low maintenance requirements. No fouling of the stamped parts by oil or heat.
- Hydraulic overload safety device for an effective protection of dies and press.
- Ram is guided in 4 lanes with hydrostatic pretention guaranteeing the same position in all working conditions i.e. no displacement out of the upper or lower part of the tool.
| P4 Double Tool | |
|---|---|
| Press force | 320 kN |
| Output max* | 840 epm |
| Cutting diameter max | 125 mm |
| Max. drawing depth | – |
| Strokes per strip | 4–20 |
| Stroke | 50–100 mm |
| Number of strokes/min* | 230–420 |
| Strip length | 710–1150 mm |
| Strip width | 70–255 mm |
| Sheet thickness | 0.14–0.35 mm |
| P4 Single Tool | |
|---|---|
| Press force | 320 kN |
| Output max* | 420 epm |
| Cutting diameter max | 210 mm |
| Max. drawing depth | – |
| Strokes per strip | 4–20 |
| Stroke | 50–100 mm |
| Number of strokes/min* | 230–420 |
| Strip length | 710–1150 mm |
| Strip width | 70–255 mm |
| Sheet thickness | 0.14–0.35 mm |
*depending on cutting diameter, sheet size and material quality
Subject to modifications
Subject to modifications